Specification:Model: X001Power: 900WSol speed: 3KG/HRSolvent capacity: 3KG/HRMaximum viscosity; 10000 CPSWorking temperature: 160-180°CTemperature control range: 0-300°CSafety Precaution:Always wear safety gloves, goggles, and long-sleeved overalls to avoid burns from hot liquid hot melt adhesive1. The gas circuit should avoid too much water vapor entering2. The hot melt adhesive capacity must not exceed seven points of the capacity of the storage bucket.3.The maximum total air pressure is set to 4KG4. Before heating the melted glue, the pressure of the storage bucket must be released first.Preparation:1. Confirm the safety protection measures2. Check if the machine is 110VAC and there is no fluctuation in the pressure3. See if the temperature of the plastic bucket is set at about 170 degrees (different hot melt adhesives have different softening points. 4. For specific setting values, refer to the data provided by the hot melt adhesive supplier)5. Check whether the foot switch is connected and whether any conductive objects have touched the components in the electric control box.6. Check if the air supply system is basically dry and the air pressure is stable7. Power on and test the circuit of each part.Boot steps:1. Connect the power and turn the power switch to ON2. Check if the temperature of the temperature controller is within the above range3. Check whether the pressure relief is turned in the direction of pressure holding4. Connect the origin, set the pressure value, and start the operationNOTE:The product needs to be used with an air compressor