Specifications:Color:orangeMaterial: Plastic + MetalVoltage: 12VBattery: Lithium Ion BatteriesBattery Capacity: 1500 mAhBattery Charging Time: 1.5 hours full fillingTying Wire Diameter: 0.8mmTying Wire Length: more than 110 mApplicable Scope Of Steel Strapping: 8mm - 34mmKnot Wire Length: 300 - 500mmKnot Number Per Charge: 1500 timesKnot The Required Time: 0.8 seconds at a timeMachine Size: 275 mm * 65 mm * 240 mm / 10.83''x2.56''x9.45''(appr.)Operation Instructions：1. The rebar tirer's jaws are stuck to the intersection of the steel bars, and the steel bars are hooked at 45 degree angles.Note: There can be no barrier between the mouth of the jaws and the wire.2. Press the start switch, the rebar tirer machine carries on the work (spins, hinges tightly, cuts off)Note: Press one button at a time, do not probe the jaws at work.3. When automatic completion, the jaw from the steel bar intersection and then pull back, complete the process and prepare for the next binding.4. When the binding process is not completed, do not unplug the machine in advance, otherwise it will cause the bundling of the goods tied skidding.Operating Skills：1. In use, the left tilt 45 degrees after banding, the next time the banding into a right tilt 45 degrees banding, left and right alternately banding.2. When the machine is about to tighten, the machine will appear slightly shaking, while holding the hand of the machine not too tight, you can relax properly.Package included:1X Tying Machine1X Pliers1X Charger 1X Storage Box2X Lithium Ion Batteries1X Tying Wire in the machine (Tying Wire Standard: About 0.8 mm x 110 m/roll)